Добавить в корзинуПозвонить
Найти в Дзене

Многоинтерфейсный Micro USB Terminal у фотокамер Sony

Назначение выводов штекера многоинтерфейсного 15 контактного USB разъема (Multi/Micro USB Terminal) у фотокамер Sony: A1-VBUS(5 volt, max 2A) A2-USB D-1 A3-USB D+1 A4-USB ID A5-Ground 1-Power On /Off-Short to Ground to toggle between Power On or Off. 2-Ground 3-Composite Video Out-Not supported when using a wired remote control unit. 4-Audio Out L/ Shutter Release -Shutter with direct trigger cable. Note: Audio is not supported when using a wired remote control unit. 5-Audio Out R Audio / Activate Camera / Focus-Focus with direct trigger cable. Note: Audio is not supported when using a wired remote control unit. 6-Select - resistor to detect the connected cable or accessory type.Resistor to Pin 2 or Pin 10 depending on accessory type or cable.Use100 kOm Resistor. 7-UART RX / Boot Serial in-optional input for serial interface (debug) and boot loader. No Boot Loader. 8-UART TX/ LANC Sig-optional output for serial LANC interface for debug / No LANC control. 9-XReset Req / input for reset

Назначение выводов штекера многоинтерфейсного 15 контактного USB разъема (Multi/Micro USB Terminal) у фотокамер Sony:

A1-VBUS(5 volt, max 2A)

A2-USB D-1

A3-USB D+1

A4-USB ID

A5-Ground

1-Power On /Off-Short to Ground to toggle between Power On or Off.

2-Ground

3-Composite Video Out-Not supported when using a wired remote control unit.

4-Audio Out L/ Shutter Release -Shutter with direct trigger cable. Note: Audio is not supported when using a wired remote control unit.

5-Audio Out R Audio / Activate Camera / Focus-Focus with direct trigger cable. Note: Audio is not supported when using a wired remote control unit.

6-Select - resistor to detect the connected cable or accessory type.Resistor to Pin 2 or Pin 10 depending on accessory type or cable.Use100 kOm Resistor.

7-UART RX / Boot Serial in-optional input for serial interface (debug) and boot loader. No Boot Loader.

8-UART TX/ LANC Sig-optional output for serial LANC interface for debug / No LANC control.

9-XReset Req / input for reset request.

10-2.8 volt to 3.3 volt output.